2/13/2024 0 Comments Instaling FlatsAll parts of the air source heat pump must be at least one metre from the property boundary.Additional wind turbines or air source heat pumps at the same property requires an application for planning permission Only the first installation of an air source heat pump would be permitted development, and only if there is no existing wind turbine on a building or within the curtilage of that property.The volume of the air source heat pump’s outdoor compressor unit (including housing) must not exceed 0.6 cubic metres.Development is permitted only if the air source heat pump installation complies with the Microgeneration Certification Scheme Planning Standards (MCS 020) 1 or equivalent standards.should not also contain commercial premises). A block of flats must consist wholly of flats (e.g. ![]() These permitted development rights apply to the installation, alteration or replacement of an air source heat pump on a house or block of flats, or within the curtilage (garden or grounds) of a house or block of flats, including on a building within that curtilage. Planning Permission: Air source heat pumpįrom 1 December 2011 the installation of an air source heat pump on domestic premises is considered to be permitted development, not needing an application for planning permission, provided ALL the limits and conditions listed below are met.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |